The Always On Module for the 2014–2024 Infiniti Q50 and Q70 lets you keep your factory fog lights illuminated as daytime running lights. This simple plug-and-play module integrates directly with the factory wiring for a clean, OEM-style upgrade — no cutting or splicing required.
Watch the full install video below, or scroll down for the step-by-step written guide.
Table of Contents
- Installation Video
- Tools Required
- Installation Instructions
- Questions About the Install?
- Shop Infiniti Lighting at Ess K Customs
Installation Video
Tools Required
- Small flathead screwdriver
- 10mm socket or wrench
Time Required: Approximately 30–45 minutes.
Installation Instructions
Step 1 — Turn the steering wheel to the left to improve access, then open the hood.
Step 2 — Using a small flathead screwdriver, remove the eight locking screws securing the front air duct. Note that the larger locking screws are used in the outermost holes and the two rear holes. Pull straight up and remove the air duct, then set it aside.
Step 3 — On the passenger side, remove the two 10mm screws securing the air box. You may need to gently lift the shroud cover to access the second screw. Once removed, pull the air box straight up and reposition it to access the headlight connector.
Step 4 — Use a small flathead screwdriver to depress the clip on the bottom of the headlight connector, then pull straight out to unplug it.
Step 5 — Plug the larger connectors on the Always On Module inline between the vehicle harness and the headlight connector. Route the remaining connectors down toward the fog light location.
Step 6 — On the passenger side, remove the locking screw in the wheel well and gently pull back the fender liner to access the fog light connector. Release the fog light connector tab and plug the module inline. If your vehicle has the optional adaptive lighting feature, you may need to reach around or underneath the adaptive lighting controller to access the fog light connector.
Step 7 — Test the module to confirm proper operation, then reinstall the original screws in the wheel well, air box, and air duct. Make sure the grommet is properly seated when reinstalling the air box.
NOTE: The factory DRL only turns on when the vehicle is started.
Questions About the Install?
If you run into any issues during the installation, contact Ess K Customs — as an authorized Diode Dynamics dealer, we're here to help.
Shop Infiniti Lighting at Ess K Customs
Ready to upgrade your Infiniti's lighting? As an authorized Diode Dynamics dealer, Ess K Customs carries genuine products with full manufacturer warranty.
Shop Always On Module for 2014-2024 Infiniti Q50/Q70 →
This install guide applies to Diode Dynamics SKU: DD3037