The Stage Series Backlit LED Ditch Light Kit for the 2017-2022 Ford Super Duty mounts two SS3 or SSC2 LED pods above the hood near the A-pillars — adding serious forward and side lighting without permanent modification. Here's the full installation walkthrough.
Table of Contents
- Tools Required
- Mounting Instructions
- Wiring Instructions
- Questions About the Install?
- Shop Super Duty Lighting at Ess K Customs
Tools Required
- Plastic trim removal tool
- Ratchet
- 13mm socket
- 4mm hex key
- 12mm wrench
Mounting Instructions
Step 1 — Install Brackets
Using a plastic trim removal tool, remove the clip holding the factory wiring harness to the hood. With a 13mm socket, loosen (but do not remove) the nuts holding the hood to the hood hinge. Slide the provided bracket completely onto the studs and tighten the 13mm nuts to 22 lb-ft. Push the removed plastic clip into the new hole on the ditch light bracket.
Step 2 — Mount LED Pods
Close the hood and mount your SS3 or SSC2 LED pod to the bracket using the included universal mounting hardware. Ensure the hood can open without interfering with the pod. Repeat on the other side.
Wiring Instructions
Step 3 — Route, Connect, and Test
Route the included wiring harness along the suggested path and secure with the included zip ties. Connect the harness to the pods and then to the battery per the included wiring guide. Test thoroughly and aim the LED pods as desired.
Questions About the Install?
If you run into any issues during the installation, contact Ess K Customs — as an authorized Diode Dynamics dealer, we're here to help.
Shop Super Duty Lighting at Ess K Customs
Looking for lighting upgrades for your 2017-2022 Ford Super Duty? As an authorized Diode Dynamics dealer, Ess K Customs carries genuine products with full manufacturer warranty.
Browse Super Duty Ditch Light Kits at Ess K Customs →
This install guide applies to Diode Dynamics SKUs: DD7551-DD7559